
Product name: anti-static rubber
Product brand: a heat
Processing custom: product size limit is small, can receive for processing
Summary:
Anti-static rubber is also called the anti-static table MATS, anti-static rubber sheet, antistatic mat, etc. Anti-static rubber mainly use (guide) electrostatic resistance material and static dissipative material such as synthetic rubber skills. Commonly used for 2 mm double composite structure, surface layer is about 0.5 mm thick, the dissipation of electrostatic layer is about 1.5 mm thick at the bottom of the conductive layer.
Laid method
In the desktop laying anti-static rubber, and then on the surface of buckle buttons, static line end at the other end connect to the earth conductor, thus collected on the surface of the table of the electrostatic discharge through the static line out its principle:
1, the green surface electrostatic around for storing absorption desktop, its resistance 10 ^ 7-10 ^ 9 Ω cm;
2, black bottom as the conductor 10 ^ 6 Ω cm or less, as a result of the conductor can quickly will absorb electrostatic discharge;
3, grounding line radio antistatic mat are connected at one end, and the other end connected to the earth, so the electrostatic by wiring drain into the earth so smoothly around the desktop electrostatic discharge out through this principle.
Folding editing this section foundation ground requirements
(1) based on the ground for water floor, ceramic floor, wooden floor.
(2) the ground to be smooth, no obvious uneven, roughness to less than two over one thousand.
(3) the ground need to have enough strength, no sand, shell phenomenon.
(4) the ground should be dry.